Page 6
TABLE OF CONTENTS
BEFORE USING THE PRODUCT.
1. PRODUCT SPECIFICATION
1.1 GENERAL SPECIFICATION
1.2 MOTION SYSTEM DESCRIPTION
1.3 SAFETY SYSTEM DESCRIPTION
2. INITIAL INSPECTION
3. NAMES OF MAJOR PARTS
4. TRANSPORTING AND MOVING
4.1 EQUIPMENT REQUIRED FOR UNLOADING AND TRANSPORT
4.2 UNLOADING AND OPENING THE CRATE
4.3 UNPACKING AND INSTALLING REAR CASTER WHEELS
4.4 MOVING THE MACHINE
5. INSTALLATION INSTRUCTION.
5.1 LOCATION REQUIREMENTS
5.1.1 ENVIRONMENT REQUIREMENTS
5.1.2 ELECTRICAL REQUIREMENTS
5.2 EQUIPMENT REQUIRED FOR INSTALLATION
5.3 STEPS FOR INSTALLATION
5.4 SECURING IN PLACE (LEG ADJUSTER ADJUSTMENT)
5.5 CONNECTING THE HEAVE ACTUATOR
5.6 CONNECTING THE SAFETY LINK
5.7 ASSEMBLING THE FLOOR SENSOR PLATES
5.8 SETTING THE PHOTO SENSORS
5.9 COIN MECHANISM INSTALLATION
5.10 CONNECTING THE ELECTRIC POWER SOURCE
5.11 POST INSTALLATION TESTING AND INSPECTION
5.11.1 TESTING AND ALIGNING THE PHOTO SENSORS
5.11.2 TESTING AND ADJUSTING THE FLOOR PRESSURE SENSOR
5.12 ASSEMBLING THE FENCE
5.13 FIGURE OF CYCRAFT AFTER FINISHING THE INSTALLATION WORK
To Next Page
Loading...
