Page 56
7. MAINTENANCE AND REPLACEMENT
7.1 ROUTINE MAINTENANCE
Maintenance and repair shall be performed only by qualified mechanical and
electrical maintenance personnel in accordance with instructions provided in
the manuals.
Routine maintenance and inspection of Cycraft should be carried out to ensure safe
operation and longevity of the machine. Contact your distributor or the manufacturer
for any instructions beyond those given in the manuals and for any questions
regarding maintenance and repair procedures.
Routine Maintenance and Frequency:
Frequency Maintenance Activity
Daily Verify that all the safety sensors (floor sensor, photo sensor, motion
stop switch) are working properly. If any malfunction is found, repair
it before accepting players.
Daily Check the system for abnormal noise and vibrations. There should
not be screeching, grinding, or rattling noises which can indicate
loose bolts or abnormally rubbing of parts. If such suspected noises
are heard, verify the source and repair or replace as necessary.
Inspect bolts and connections and the integrity of the mechanical
system as described below.
Weekly Verify that all the bolts connecting the outer frame, actuators and
cabin are not loose according to the procedure described in the next
section. Tighten if necessary.
Weekly Verify that the snap rings in each of the universal joints are lodged in
their grooves correctly according to the procedure described in the
next section. The snap ring must be set securely in place.
Monthly Check all weld areas of the frame and actuator described in the next
section for cracks or other damage. None is acceptable.
Monthly Check the actuator drive belt for indication of tears, cracks, or other
damage. Exchange immediately if any damage is found.
Monthly Clean the MSCU air filters and fan.
Every 6 Months Lubricate the actuators with grease provided by manufacturer or
equivalent.
Every 18
Months
Lubricate the joints with grease provided by manufacturer or
equivalent
To Next Page
Loading...