• Thread the tep cover thread
guide by pulling the thread
downward until it slips
under thread guide 2.
- While holding thread with finger, pass it between
the tension discs and pull thread down to make
certain it is properly !ocated in between the
tension discs 3
• Thread the looper area of the machine following the
orange color coded thread guides ( 4 _ 7 )
• Thread the hole in the upper looper from front to
back 8.
Note: Use of tweezers provided in the accessory
set to aid in threading the _ooper
Pull about lOcm (4 inches) of thread through the
looper and place to the back of the threat piate.
J
13
To Next Page
Loading...
