Additional information About Roiled Hemmin£
Hoid the thread chain when you begin sewing to
keep it from curiing into the seam
Piace a slight tension on the mateda_ in the sewing
direction and a finer seam tinish can be obta ned,
The minimum overedge stitch width that can be
obtained for to!ted hemming is approximately 1.
5ram (1/16 inch) since the cutting width cannot be
set be_ow 3oSmm (9,t64 inch},
To Secure the Roiled Hem Thread Chain
• Apply a. smaii drop of liquid seam sea!ant to the
end of the seam Aiiow to d:ry, then cut the chain
ClOSe to i the stitches.
Note: Test the _iquid seam sealant for co_o_
fastness before use
39
To Next Page
Loading...
