An over!ock requires more maintenance than a
conventiona_ machine mainiy due to two reasons_
1) A _otof }int is produced due to the cutting action
of the knives,
2) Ar_ overlook runs at a very high speed and needs
to be oiled frequendy to _ubricate the internal
working pe!ts.
Ii Cleaning the Machine
Before cleaning your machine, disconnect
power line plug from the waii receptacle,
•Ciean |he _iatfrom the looper and knife area often
with a dry Ha|:brush_
Nots: Lint brush is an optiona_ part,
I Oiiing the Machine
Danger:
Before {ubricating your machine, disconnect
power line ptug from the wall recep_ade_
, The oiling points shown in the diagram, should be
oiled periodically
Note: Use sewing machine oi_ Do not use any
other oi_ or damage could result,
46
To Next Page
Loading...
