- To change thread type or coior, c_ipthread near the
spooi,
o Place new thread on stand,
i Tie new thread and o_d thread ends together,
Cli# thread tai!s to 2 _ 3cm (1 inch) _ength_
if c_#ped too sho_, threads may come untied,
Firmiy puliboth thread to test knot security
• Note tension dial settings.
o Tl_m the tension d_ais down unti{ the d_at stop&
t pe_! the threads through the machine one at a t_me_
• if threads de not pull easily,, check for tangles on
thread guides or !ooping under thread start&
When pu_ing thread through the needle_ STOP when
_he knot is in front of the needle
• Cut the thread_ and _nsert it through the need_e_
" Rett_m tension dials to previous settings.
2O
To Next Page
Loading...
