• Turn the hand wheel toward you until the !ower
iooper is at the far righL
Thread the iooper area of the machine fo[fow[ng
the ye[tow ootor coded thread guides 4 - 7
Note: Use the tweezers provided in the accessory
set to aid in threading the _ooper,
• Grasp the thread with the tweezers 4 cm (1_1/2
inches) from thread guide 7
•Piace the thread with the point of the tweezers
siightly under and to the }eft of threading guide 8,
t Puil the thread up and into thread guide 8,
Pass the thread behind and over the top end of
_eft looper 9*A_
Then puJi it downward gently so that it wiil slip
into the slot in the iooper goB.
• Pick up the thread and pass it:through the hole in
the end of the _ooper 10
Note : Use the tweezers provided in the
accessory set to aid in threading the
_ooper
• The thread should be positioned in the groove of
the lower _ooper.
• Pull about 10cm (4 inches) of thread through the
_ooper and place it: over the top of the upper
looper and to the back o_the throat plate
i 5
To Next Page
Loading...
