SINO SDS2-2MS - Page 40

Key
Key
10) Enter the end angle of the arc.
Key
Key
11) Determine inner/outer circle mode.
Key or
Key
Key
12) It is display that the processing start at
the first point.
Use a circular arc milling tool
setting as Fig. (a)
Use a circular arc milling tool
setting as Fig. (b)
Use a flat end milling tool
setting as Fig. (a)
Use a flat end milling tool
setting as Fig. (b)
13) Move the machine tool to bring the
display value on X- and Y-axes
into zero, reach the start point of R.
14) Key or and the position of any processing point may come to be
displayed, and you can move the machine tool to bring the display values
â
7
å
æ
å
é
SEL
SEL
SEL
SEL
SEL
SEL
SEL
SEL
SEL
SEL
SEL
SEL
SEL
SEL
SEL
SEL
SEL
SEL
SEL
SEL
SEL