Y axis display 0.
12) Enter PCD function, process the six small
holes distribute uniformly on the circle
center at Point 3.
Key
13) The processing of the six small holes has been
finished, return to Point D, the display
should be:
For PCD function, please refer to the
related sections.
Ⅴ
ⅤⅤ
Ⅴ. The Clearing of Subsidiary Zero Positions and Other
Related Problems.
1. The Clearing of Subsidiary zero positions
In absolute state (ALE state), key 10 times continuously, the memory
about all the subsidiary zero positions will be cleared, the 200 subsidiary zero
positions will become the same point of the zero position in the absolute state.
2. Reset during a subsidiary zero position is being used
A subsidiary zero position is being used of course under the display mode
of the corresponding UCS, resetting in this state is actually to reset a new
subsidiary zero position. The point at which the resetting operation act become
the new subsidiary zero position, and the new subsidiary zero position
replacing the original subsidiary zero position.
3. Turn to one half during a subsidiary zero position is being used
“1/2” function may be used under UCS display mode. Turning to one
half under the UCS display mode using a subsidiary zero position is actually
also resetting a new subsidiary zero position. After the operation of turning to
one half act, the original subsidiary zero position will be replaced by the new
SEL
SEL
SEL
SEL
SEL
SEL
To Next Page
Loading...
