200 subsidiary zero position function:
200 auxiliary zero position function: also is called 200 user Coordinate
System(UCS) function.
ALE: Absolute Coordinate System.
ALE is the “reference” system. All 200 UCS are defined relative to the
ALE. ALE is confirmed in the initialization of the work piece process, which
doesn’t change if the work piece no changed.
UCS: User Coordinate System.
In the processing of moulds, often it would not work with only one
reference zero position, normally, a lot of subsidiary zero positions is
necessary. In the processing of a large or medium lot of complicated
drilling/milling fittings with multi point dimensions, it is also necessary to
have a lot of fixed point positions in order to perform the processing of a
series of structures with dimensions referred to these point position. In these
cases, if there is only one reference point, the working efficiency will be rather
low, as you have to find out the correct position point by point, more over, it
may be very difficult for complicated moulds or molding fittings to do in such
a way. The function 200 point subsidiary zero positions is specially provided
as a good resolution for this problem.
Ⅰ
ⅠⅠ
Ⅰ. The operator must know the following two key points before
making use of this function.
1. Every subsidiary zero position is equivalently the original point of one UCS.
Once entering the display mode of such UCS, the display of every point
will take the subsidiary zero position as the original point.
To Next Page
Loading...
