© Jun. 2021 3-10 1323RE&1623RE Operation Manual
SAFETY
BATTERY HAZARD
• Only the properly trained
personnel authorized by the
workplace are allowed to remove
the battery from the machine.
• Before replacing the battery, be
sure to identify the appropriate
number of personnel and the
lifting method.
• During the assembling or
disassembling process, never use
the battery in a forciable manner,
and never allow the battery to fall
off.
• Never directly short-circuit the
battery outputs with electrical
cords.
• Should the battery acid spill out,
use bicarbonate (baking soda)
mixed with water to neutralize the
acid.
• Never store the battery in water or
humid atomosphere.
• Daily check the battery cable for
damage, and replace any
damaged parts before operating
the machine.
LITHIUM BATTERY HAZARD
• Only use the dedicated charger to
charge the battery.
• Do not allow lens, needles or
other sharp objects to contact
with the battery, otherwise the
battery membrane will easily get
damaged.
• Do not immerse the batttery into
the sea or water for an extended
period of time.
• Do not use the machine with the
battery close to a heat source (-
fire, heater, etc).
• Do not use the battery with the
positive or negative terminals
installed inversely.
• Do not directly connect the
battery to a power outlet .
• Do not throw the battery into a fire
or heater,
NOTICE
After charging the battery, be sure that:
• The battery cable connections are free of
corrosion.
• The battery hold-down and cable connections are
secured.
Adding terminal protection and anti-corrosion
sealants will help reduce corrosion of the battery
terminals and cables.
To Next Page
Loading...
