© Oct 2020 1-12 AB18EJ&18HJ Maintenance Manual
SAFETY
WELDING HAZARDS
• Comply with the welder
manufacturer’s recommendations
for procedures concerning proper
use of the welder.
• Welding leads or cables may only
be connected after turning off the
power unit.
• Carry out welding operations only
after the welding cable has been
correctly connected.
• Do not use the machine as a
ground wire during welding
operation.
• At all times, make sure that the
power tools are completely stored
in the working platform. Do not
hang the power tools on the
railing of the working platform or
the work area outside the working
platform, or hang the power tools
directly by the wire.
Before performing welding, grinding and polishing work,
welders must seek permission of the responsible
department at the workplace.
AFTER USING THE
MACHINE
1. Choose a safe parking location that is on sturdy,
level ground and that is free of obstructions. Avoid
areas with heavy traffic.
2. Lower the boom to stowed position.
3. Take off all loads from the platform and run the
enghine at low speed for 3–5 minutes to reduce the
engine inside temperature.
4. Push in the emergency stop button at the platform
controls to the OFF position.
5. Close the cover of platform controls to protect the
control panel,handle and controller from hostile
weather conditions.
6. Push in the emergency stop button at ground
controls to the OFF position.
7. Turn the key switch at the ground controls to OFF
position and remove the key to avoid unauthorized
operation of the machine.
8. Turn off the main power switch.
NOTICE
After using the machine, the main power switch must
be disconnected.
To Next Page
Loading...
