© Mar 2021 3-6 GTJZ0608E&0808E Operation Manual
SAFETY
UNSAFE OPERATION HAZARDS
• Do not allow the platform to touch
nearby objects.
• Do not tie the platform onto
nearby objects.
• Do not put the load outside the
platform.
• When the platform is caught or
stuck or when other objects in the
vicinity impede its normal
movement, do not use the
platform controller to lower the
platform. If you intend to lower the
platform with a ground controller,
you must operate it only after all
personnel have left the platform.
• Do not operate the machine when
the chassis door box is open.
• When one or more of the
machine’s tires are off the ground,
evacuate all personnel before
attempting to stabilize the
equipment. Use a crane, forklift or
other suitable apparatus to
stabilize the equipment.
FALL HAZARDS
At a minimum, operators must operate and maintain the
machine as stated in Operation Manual and in the
Maintenance Manual in addition to following more
stringent industry regulations and workplace rules.
FALL HAZARDS
• Each person on the platform must
wear harnesses or use safety
equipment consistent with gov-
ernment regulations. Fasten the
cable to the fixed point of the plat-
form. Never fasten the cable of
more than one person to a fixed
point on the platform.
• Do not sit, stand or crawl on the
guardrails. When on the platform
always remain standing on the
platform floor.
• Do not climb down from the plat-
form when the platform is
elevated.
• Keep the platform floor free of
obstacles.
• Do not enter or exit the platform
unless the machine is fully in
place.
• Close the platform entrance door
before operating the machine.
• Do not operate the machine if the
handrails are not properly in-
stalled and the platform entry
door is not closed.
COLLISION HAZARDS
At a minimum, operators must operate and maintain the
machine as stated in this manual and in the Mainte-
nance Manual in addition to following more stringent in-
dustry regulations and workplace rules.
To Next Page
