OPERATING THE MACHINE
GTJZ0608E&0808E Operation Manual 7-5 © Mar 2021
6. Fold down the door and the side rails at the entry
door as a piece. Do not reach your hands into the
place that may have pinch hazards.
7. Fold the side rails. Do not reach your hands into the
place that may have pinch hazards.
To unfold the rails：
Operate in reverse order as stated above to unfold the
rails. Ensure the wire rope safety pins are properly
secured after unfolding the rails.
DRIVING ON A SLOPE
Before driving on a slope:
1. Determine the climbing ability of the machine, which
is 25% or 14 degrees.
2. Ensure the platform is fully folded.
3. Ensure that the slope where you plan to drive is less
than the angle of the machine’s climbing ability.
NOTICE
Climbing ability refers to the maximum permissible
percentage of the slope when the machine is on solid
ground with sufficient traction and the platform is car-
rying only one person. As the weight of the machine’s
platform increases, the machine’s climbing capacity
reduces.
To determine the slope:
1. Use a carpenter’s rule, a straight board (longer than
1 m [3.3 ft]), and a tape measure.
Figure 7-4
2. Measure the height and length/distance of the
slope.
3. The slope measurement consists of the numbers
for the height and length/distance x 100%.
NOTICE
To avoid the wheel from dangling, the machine
should not be driven for more than 2 minutes on
slopes with the maximum climbing capacity allowed,
and be sure that the temperature of the motor shell
does not exceed 70 ℃.
INSPECT BATTERY LEVEL
Use the diagnostic reading display on the platform
to determine the battery level.
Table 7-2
PLATFORM POWER DISPLAY POWER RATIO DESCRIPTION
90-100%
The battery has been fully charged.
70%
The battery is at 70% of its capacity.
50%
The battery is at 50% of its capacity.
30%
The battery is at 30% of its capacity.
To Next Page
Loading...
