Sinoboom GTJZ0608E - Operation from Ground; Operation from Platform

OPERATING THE MACHINE
GTJZ0608E&0808E Operation Manual 7-3 © Mar 2021
OPERATION FROM
GROUND
UNSAFE OPERATION HAZARD
• Unless in emergency situations,
do not operate from the ground
controller when there are person-
nel in the platform.
• Do not operate the machine if any
control handle or switch is not re-
turned to off position after being
released.
Before operating the machine:
1. Turn the key switch on the ground controller to the
ground control position.
2. Pull out the emergency stop button on the ground
controller to the ON position.
3. Ensure the battery is properly connected.
Platform up/down：
Simultaneously hold the enable switch and the platform
up/down switch to raise/lower the platform.
Move upwards/downwards the platform up/down switch
to raise/lower the platform.
To drive：
The drive function is not enabled from the ground
controller.
To steer：
The steer function is not enabled from the ground
controller.
OPERATION FROM
PLATFORM
UNSAFE OPERATION HAZARD
• Unless in emergency situations,
do not operate from the ground
controller when there are person-
nel in the platform.
• Do not operate the machine if any
control handle or switch is not re-
turned to off position after being
released.
Before operating the machine:
1. Turn the key switch on the ground controller to the
platform control position.
2. Pull out the emergency stop buttons on the ground
and platform controllers to the ON position.
3. Ensure the battery is properly connected.
Platform up/down：
Press the up/down function switch, hold the enable
switch on the control joystick and push forward/back-
ward the control joystick to raise/lower the platform.
To drive：
1. Press the drive/steer function switch, hold the ena-
ble switch on the control joystick and slowly push
forward/backward the control joystick to drive for-
ward/reverse.
2. Speed up：slowly move the joystick off center.
3. Speed down：slowly move the joystick towards
center.
4. Stop：return the joystick to neutral or release the
enable switch.
When the platform is raised, the drive speed will be
limited.
The battery condition will affect the machine perform-
ance. When the platform display indicates a low battery
level, the drive and lift speeds of the machine will slow
down.
To steer：
Press the drive/steer function switch, hold the enable
switch on the control joystick, slowly push forward the
control joystick and press and hold the steer rocker
switch to steer left/right.
To shift speed：