2
3. Specification
Rating 230V～50Hz, 2.2KW
Blade no-load speed RPM 2800
Blade tilt 0°～45°
Table dimensions mm 560x800
Table extension mm 305x800
Working table height mm 860
Saw blade diameter ￠mm 254
Blade Bore Dia. ￠mm 25.4mm
Cutting capacity (0°) mm 75
Cutting capacity (45°) mm 60
4.Safety
4.1 Specified conditions of use
This machine is intended to rip and crosscut grown timber,
faced boards, chip board and wood-core plywood sheets,
and similar wood-derived materials.
Do not cut round stock without suitable jigs or fixtures.
The rotating saw blade could turn the work-piece. When
sawing thin stock layed on edge, a suitable guide must be
used for firm support.
Use of wobble saw blades is not permitted on this
machine.
Danger! Any other use is not as specified.
Use not as specified, alteration of the electric tool or use
of parts that are not approved by the equipment
manufacturer can cause unforeseeable damage!
4.2 General safety instructions
1. Keep work area clear
- Cluttered areas and benches invite injuries.
2. Consider work area environment
- Do not expose tools rain.
- Do not use tools in damp or wet locations.
- Keep work area well lit.
- Do not use tools in the presence of flammable liquids
of gases.
3. Guard against electric shock
- Avoid body contact with earthed or grounded
surfaces. (e.g. pipes, radiators, ranges, refrigerators).
4. Keep other persons away,
- Do not let persons, especially children, not involved in
the work touch the tool or the extension cord and
keep them away from the work area.
5. Store idle tools
- When not in use, tools should be stored in a dry
locked up place. Out of reach of children.
-
6. Do not force the tool
- It will do the job better and safer at the rate for
when it was intended.
-
7. Use the right tool
- Do not force small tools to do the job of a heavy duty
tool.
- Do not use tools for purposes not intended ; for
example do not use circular saws to cut tree limbs or
legs.
8. Dress properly
- Do not wear loose clothing or jewellery, they can be
caught in moving parts.
- Non-skid footwear is recommended when working
outdoors,
- Wear protective hair covering to contain long hair.
9. Use protective equipment
- Use safety glasses.
- Use face or dust mask if working operations create
dust.
10. Connect dust extraction equipment
- If the tool is provided for the connection of dust
extraction and collecting equipment, ensure these are
connected and properly used.
11. Do not abuse the cord
- Never yank the cord to disconnect it from the socket.
Keep the cord away from heat, oil and sharp edges.
12. Secure work
- Where possible use clamps or a vice to hold the work.
It is safer than using your hand.
13. Do not overreach
- Keep proper footing and balance at all times.
To Next Page
Loading...
Need help?
General
