MK15E User Manual V1.1
46
2022 SIYI Technology, All Rights Reserved
If your flight controller communicates with your MK15E Air Unit through S.Bus protocol,
then it is unnecessary to configure your MK15E system with Failsafe function(unless it is
specially required by flight controller to trigger Failsafe function and switch to RTH, by
holding a specific value in a channel). You just configure your GCS with protection
measures, because there are Out-of-Control marks in S.Bus protocol which tells flight
controller what situations belong to Out-of-Control.
3.6 Buttons / Dials
MK15E transmitter supports changing the way that the buttons and the dials work
by software.
3.6.1 Buttons
The function changes the way that the four buttons (A, B, C, D) on MK15E
transmitter works.
To Next Page
Loading...
