MK15E User Manual V1.1
3
2022 SIYI Technology, All Rights Reserved
When you start your aircraft/vehicle for the first time, make sure that the fail-safe
settings in your transmitter is activated.
Always switch on the transmitter first and hold the throttle joystick at its bottom
position, then power on your aircraft/vehicle/model.
Battery
MK15E transmitter is equipped with a built-in and chargeable 10200mAh Li-on
battery and a 20W PD fast charger. Please do read the precautions before using
and charging MK15E battery.
Please power off MK15E transmitter before charging. The transmitter does not allow
charging while it is working.
Stop charging immediately if you found the charger damaged, broken or overheat.
Stop charging immediately if there was a peculiar smell, smokes or leaks. In such cases
you shall sent the transmitter back to your dealer for after-sales service.
Do not charge the transmitter when temperature is high, or battery temperature is over
60℃.
Memory Card (SD/TF)
The memory card slot at bottom MK15E transmitter supports reading from and
writing into high-speed SD/TF card. Please mind the precautions below.
To Next Page
Loading...
