MK15E User Manual V1.1
70
2022 SIYI Technology, All Rights Reserved
Let’s take QGroundControl as an example.
1. In camera settings, check and copy the RTSP address of your IP camera/pod.
2. In QGC, go to “General” page and slide to “Video Settings”.
3. Configure “Source” as “RTSP Video Stream”. Then input the copied RTSP
address of your IP camera/pd after “RTSP URL”.
4. Go back to QGC home page to check image display.
6.3 Using HDMI Cameras / Pods
If you use SIYI original HDMI converter to connect MK15E Air Unit with your HDMI
camera, please refer to the steps below for acquiring image transmission.
Let’s take QGroundControl as an example.
1. Open QGC, go to “General” page and slide to “Video Settings”.
2. Configure “Source” as “RTSP Video Stream”. Then input SIYI HDMI converter’s
RTSP address after “RTSP URL”.
3. Go back to QGC home page to check image display.
To Next Page
Loading...
