EasyManua.ls Logo

SKF IMx-16Plus - Storage Capacity; Data Processing Memory; Certifications; Quality Control

SKF IMx-16Plus
66 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
PRODUCT SPECIFICATIONS
SKF Multilog On-line System IMx-16Plus
SKF Multilog On-line System IMx-16Plus
User Manual
Revision Letter A
53 (66)
o RJ45 and Wi-Fi share a MAC address, not for simultaneous use
o Support for Modbus TCP/IP (master and /or multiple slave instances)
o Support for IEC 61850 (communications networks in a sub-station
environment)
• GPS location data provided by an external GPS module (optional)
o Communication by Modbus RTU (see RS485 below)
o GPS with support for Satellite-Based Augmentation Systems
o Antenna is integral to the GPS module
• RS485 2-wire serial interface, Modbus RTU
o ‘RS485’ (top end cap) for Modbus sensor or GPS module etc.
o Note that the terminals marked ‘RS485B’ (bottom end cap) are not
used / not available
• USB Type-A (host interface) – fitted with an SKF Bluetooth dongle
o Bluetooth v4.0 LE (Low Energy)
• USB Mini-B (device service interface)
o Always use an isolated USB cable, CMON 4133 Mini USB cable
(isolated), to avoid ground loops when connecting to mains powered
equipment
3.2.10 Storage capacity
• 4 GB effective flash memory, configured for pSLC (pseudo single level cell)
mode for higher reliability than normal MLC (multi-level cell) mode
3.2.11 Data processing memory
• 64 MB RAM for data processing
3.2.12 Certifications
• Calibration traceable to BIPM
• EMC, when the IMx-16Plus is placed inside a metal outer enclosure:
o EN/IEC 61000-6-4, EN 50121-3-2, ETSI EN 301 489-1, -17
• CE certified:
o 2014/53/EU (RED) including ETSI EN 300 328, ETSI EN 301 908-1
• FCC certified (North America):
o FCC Part 15B 107/109, ICES-003, FCC Part 15C 15.247 (d),
RSS-447 sect. 5.55.5
o FCC Part 22H 917/RSS-132 sect. 5.5, FCC Part 24E 328/RSS-133,
FCC Part 25.53(h)/RSS-139
• DNV GL Renewables certificate – valid only when the IMx-16Plus DIN rail
version is mounted in an IP65 cabinet in a wind turbine that is built according
to the DNV GL wind turbine type approval (pending)
• DNV GL Marine type approval (pending)
• ABS Marine type approval (pending)
• Lloyd’s Register Marine type approval (pending)
BIPM: International Bureau of Weights and Measures
3.2.13 Quality control
• SKF Sverige AB, Luleå is ISO 9001:2015 certified

Table of Contents