SKF KFG User Manual

Page 77
EN
Device display - three-digit LED display
Continuation of "Three-digit LED display" table
Display Meaning Statement Control function
Pressure Switch
Pressure switch
(single-line systems)
Low Level fault: fill
level too low.
Fault Cycle Switch
fault: Piston detector
Fault Pressure Switch
Fault: Pressure switch
Operation Hour Meter
Operational hours
counter
Fault Hour Meter
Fault-hours counter
Block mode
Pressure switch monitoring is
active.
The minimum fill level has been
reached in the reservoir.
No signal from piston detector
during pump cycle.
No signal from pressure switch
during pump cycle.
The values shown after this are
the number of hours the control
unit has operated.
The system pressure is moni-
tored by the pressure switch
during the pump cycle
The control unit is currently in
FAULT mode. The operational
sequence has been stopped.
The control unit is currently in
FAULT mode. The operational
sequence has been stopped.
The control unit is currently in
FAULT mode. The operational
sequence has been stopped.
The values shown after this are the number of fault hours, i.e.,
the amount of time the vehicle or machine was operated in FAULT
mode.
No signal from the piston detector. Unlike in normal mode, the
control unit is still the monitoring sequence. A fault notification is
issued if the fault remains for three pump cycles times.
9. Display and control unit
KFGS

SKF KFG Specifications

General

Brand	SKF
Model	KFG
Category	Water Pump
Language	English