Page 96
EN
Maintenance work
Maintenance work Action Interval
KFG; KFGS; KFGC
Check of fill level in lubricant
reservoir
Refill if necessary. Depends on planned lubricant consumption
Inspection of system
components (lubricant
lines, connection points, seals,
etc.) for leaks
Parts that exhibit leaks must be replaced.
Please contact an SKF service office.
After each refill of the lubricant reservoir or after
long operational pauses before commissioning the
machine/vehicle
Visual inspection of bearings'
lubrication
In case of insufficient bearing lubrication, a fault in the
lubrication system or incorrect system configuration
is the probable cause. Observe the instructions contained
in these operating instructions. If necessary, please con-
tact an SKF service office.
In conjunction with lubrication reservoir filling
KFGS; KFGC (CAN bus)
Check of basic function of
control unit and system
components
To inspect the basic functions, trigger an interim lubrica-
tion by pressing the
key or send the corresponding
CAN command.
After each lubrication reservoir filling
Inspection of electrical cables
for damage
Damaged cables must be replaced. Please contact an
SKF service office.
After long operational pauses before commissioning
the machine/vehicle
Inspection of electrical con-
nections and contacts for firm
attachment and corrosion
Tighten loose contacts. Clean any corroded electrical
contacts with a wire brush, then apply a small amount of
contact grease after installation
Semi-annual
14. Maintenance
KFGS
KFG
KFGC
To Next Page
Loading...
Need help?
General
