15
Solid lubricants
Solid lubricants may only be used after prior consultation with SKF. When solid lubricants are used in lubrication systems,
the following rules generally apply:
Graphite:
• Maximum graphite content 8%
• Maximum grain size 25 µm (preferably in lamellar form)
MoS2:
• Maximum MoS2 content 5%
• Maximum grain size 15 µm
Copper:
• Lubricants containing copper are known to lead to coatings forming on pistons, bore holes, and mating surfaces. This
can result in blockages in the centralized lubrication system.
Calcium carbonate:
• Lubricants containing calcium carbonate are known to lead to very heavy wear on pistons, bore holes, and mating
surfaces.
Calcium hydroxide:
• Lubricants containing calcium hydroxide are known to harden considerably over time, which can lead to failure of the
centralized lubrication system.
PTFE, zinc, and aluminum:
• For these solid lubricants, it is not yet possible to define any limit values for use in lubrication systems on the basis of
existing knowledge and practical experience.
To Next Page
Loading...
