Skipper ESN100 - 24 VDC power

Page 11 of 56
SKIPPER Electronics AS
Edition: 2021-09-16
ESN100 Operation and Installation Manual
Chapter: Introduction and Specication
24VDC power
Both ESN100-SB Display and Transceiver unit JB50E1-SA requires 24VDC power supply.
Alternative 1: Display powered from JB50E1-SA
In this conguration the system is switched on/o by the power switch inside JB50E1-SA unit.
Power input circuitry inside JB50E1-SA with resettable fuse 2,5A (at 20deg C) power on/o switch and
available 24VDC output to display unit.
24VDC
Input
24VDC
Output to
ESN100-SB
Display