Skipper ESN100 - SKIPPER Transducer Setup

Page 15 of 56
SKIPPER Electronics AS
Edition: 2021-09-16
ESN100 Operation and Installation Manual
Chapter: System Setup
SKIPPER Transducer setup
Once connected the system requires the installer to identify which transducer is connected to which of the 2
connectors. Both connectors can have a 50, 200 or combined 50/200 transducer tted. To select the correct
xture, start the system and go to the cong menus, and then the ES setup.
Here you can select the Transducer menu and by clicking on the transducer connector port you can move the
transducer to the appropriate area of the vessel, and select the transducer, by part number. is will change
the parameters to match your transducer.
If only one transducer is installed (to transducer 1) then “Transducer 2” must be set to position “Not con-
nected”.