Page 7 of 56
SKIPPER Electronics AS
Edition: 2021-09-16
ESN100 Operation and Installation Manual
Chapter: Installation
Installation
e ESN100 comprises of 2 units and up to 2 transducers
ESN100-SB Control unit: is display contains a single NMEA output, dual NMEA input and a communica-
tion pair to the transceiver. An additional RJ45 connector can be used for LAN communication.
JB50E1-SA Transceiver unit; is unit contains connections for 2 transducers (of either 50 or 200kHz) a con-
nection for a single paired wire to the Control unit (Using RS485), and 24VDC power input. is unit can
be mounted on the bridge, with long cables coming from the transducers, or near the transducer for lower
noise.
e NMEA will typically be sent to a splitter to give the information to the bridge/alarm system and VDR.
To Next Page
Loading...
