Skipper ESN100 - Introduction and Specification

Page 6 of 56
SKIPPER Electronics AS
Edition: 2021-09-16
ESN100 Operation and Installation Manual
Chapter: Introduction and Specication

e SKIPPER ESN100 is a navigational echo sounders. It is made to fulll the ISO/IMO standards, as well as
the modern IEC standards for maritime equipment and alarm handling.
Features include:
• Easy and logical operaon via a touch display
• Flexible installaon with minimal wiring
• Basic but comprehensive communicaon and features
e system has a single active channel, and can be used on both 50 or 200 kHz transducers. e system is
simple to install, and simple to use having automated functions such that the need for adjustment is minimal.
Specication:
Function Value
Frequency (selectable) 50kHz and 200kHz
Two transducers can be connected at one time. Only one is
operational at a time.
Both transducers can be 50kHz and or 200kHz. If dual fre-
quency 50/200kHz transducer, an automatically switching
of frequency may be programmed (200kHz in shallow water
0-100m, 50kHz in deeper water >100m)
Electrical parameters
CU-M001-SB Control Unit
JB50E1-SA Transceiver unit
Nominal 24VDC ( Max 4W) 21VDC to 36VDC
24VDC (Max 8W) limits 21-36VDC
Connections
ESN100-SB Control unit
JB50E1-SA Transceiver unit
WAGO spring connector (12 pins)
1 port RJ45 (IEC61162-450)
1 x 2 pole connector 24VDC In( up to 1.5mm)
1 x 2 pole connector 24VDC Out to display( up to 1.5mm)
2x 3 pole connector for transducer (up to 1.5mm)
1x 2 pole connector for communication (up to 1.5mm)
1x 2 pole connector for power alarm (up to 1.5mm)
Acoustic output Power (Max) 600W
Outputs from control unit 1 x NMEA (IEC61162-1)
DPT,PSKPDPT, DBS,DBK,DBT, ALR, ALF
Inputs to control unit 2 NMEA (IEC61162-1)
Accepting signals from GPS, Gyro, Alarm, Dra, Dimming
Alarms Follows IEC standards (ALF and ALR)
Functions Auto Gain, TVG and Power
Transducer positioning
Internal sounder for alarm/button press
Depth logging Basic 24 hours,
External logging feature over network.
Transducer type, frequency, expected
min/max depth range
ETN050, 50 kHz, 1m-450m
ETN200, 200kHz, 1m-250m
ETN200S, 200kHz, 1m-200m
ETS50200, 50kHz and 200kHz, 1m -450m