Skipper ESN100 - Page 16

Page 16 of 56
SKIPPER Electronics AS
Edition: 2021-09-16
ESN100 Operation and Installation Manual
Chapter: System Setup
Selectable transducer types
Part number Type Approved for
use
ETN050 50 kHz of types ETN50(X)G, ETN50(X)T Ye s
ETN200 200kHz of types ETN200(X)T Ye s
ETN200S 200kHz of type ETN200S(X)G, ETN200S(X)G Ye s
ETS50200 Combined 50 and 200kHz of types ETS50200(X)G and
ETN50200(X)T
Ye s
Other 50 kHz Any other 50 kHz* No
Other 200 kHz Any other 200 kHz* No
*max power from system is 600W, in case of transducers other than SKIPPER approved they should be checked for
max power.
Standard transducers have the required values set for “Max power” and “Max range”.
ese can be changed in the settings of ‘Other’ See section ‘Other Transducers’
At least 1 installed transducer should be within the SKIPPER approved list.
Non SKIPPER transducers setup
If other transducers are selected then the following parameters may be changed
Screen Function
Transducer connector number, Selected by
pressing or touching the green position
Dra of this sensor, can be changed on
main screens
Position (FWD,AFT,PORT,STRB,
Oset. Distance from transducer to keel
Part number, or Other 50 or Other 200
Frequency 200 or 50 kHz
If 2 frequency transducer this is the low
frequency
If 2 frequency transducer this is the high
frequency
Min Pulse width at shallow water
Maximum range of this transducer (limits
the ESN100 to this range
Maximum power for this transducer
(100% is approx. 700W)