Skoda Octavia III 2013 User Manual

17 - Bolt
❑ 8 Nm
18 - O-ring
❑ replace after removal
❑ wet with engine oil
19 - Bolt
❑ 9 Nm
1.2 Removing and installing exhaust gas
turbocharger
Special tools and workshop equipment required
♦ Screw plug set for engine, e.g. - VAS 6122-
♦ Pliers for spring strap clamps
♦ Release tool - T10527-
♦ Release tool - T10527/1-
Removing
Note
♦ Observe rules for cleanliness
⇒ “3.1 Rules of cleanliness”, page 7 .
♦ Fit all heat protection sleeves on again in the same place when
installing.
Caution
In case a mechanical damage to the exhaust gas turbocharger
is found, (e.g. damage to the compressor wheel), it is not suf‐
ficient to only replace the turbocharger. In order to avoid con‐
sequential damage, the following tasks must be performed:
♦ Inspect the air filter housing, the air filter element and air
guide hoses for contamination.
♦ Inspect the whole charge-air routing and charge air cooler
for foreign bodies.
♦ If foreign bodies are found in the charge air system, clean
the charge air duct and replace the charge air cooler if
necessary.
– Drain coolant ⇒ “1.2 Draining and filling coolant”, page 147 .
Octavia III 2013 ➤ , Octavia III 2014 ➤
1.2/63; 77 kW TSI engine - Edition 11.2014
1. Exhaust gas turbocharger 223
ProCarManuals.com

Skoda Octavia III 2013 Specifications

General

Brand	Skoda
Model	Octavia III 2013
Category	Automobile
Language	English