Sky Control SC8110 - Extension Modules Specifications

Power
SC408 SC450
Power input: 12V. Recommended to use at all times.
■ ■
Power over CAN: Possible if module is the only one in a chain (or rst in a chain of 2 or 3 sensors) with
CAN cable length no longer than 2m.
■ ■
Inlets/Outlets
SC408 SC450
Analog: 8*6P4C for connection of analog sensors
■ □
CAN: 2*6P6С for connection of up to 8 CAN sensors on each BUS. CAN sensors and modules connect in a
chain. Fuse protection on each line.
■ ■
Air ow heat sensors: Response time 2 min, recovery time 1 min; Temperature measurement range -40
... +100 ° C, accuracy 2 ° C
□ ■
Other Features SC408 SC450
Installation: At the bottom there are four mounting holes for mounting screws
■ ■
Dimensions (L x W x H) in mm: 110×68×40 86×48×25
Weight: 0.6 kg 0.6 kg
Extension modules
A
ll Sky Control main/master modules allow connection of extension units through CAN ports. It is
possible to connect up to 8 CAN sensors/units to one CAN bus.
08
Charts and specications
■ Built-in □ None