Set the appliance to «Normal» mode. In order
to do this, turn off the appliance, open the
cover, switch the DIP switch 1 “Recovery” in the
lower right corner of the motherboard to the
mode “OFF”. Make sure that DIP switch 2 is set
to “ON”. If the appliance has GSM modem, con-
nect modem cable back to modem connector
J5. Close the cover, turn the power on, and test
the system.
Attention! Before starting operation, make
sure you press the appliance “Reset”
button or turn on/off the power, otherwise the
program will not be able to connect appliance.
Disconnection and connection of con-
nector labeled “J5 = Modem” should be
performed only when the power is off.
44
Upgrade and restore
To Next Page
Loading...
