Skyjack Rough Terrain 800E Series User Manual

DC Electric Full-size RTs
December 2007 Page 35
TM
Section 2 - Operation Function Tests
Test Driving•
1. Ensure path of intended motion is clear.
2. Activate and hold “
”enable trigger
switch.
3. Slowly move controller handle in “
”
forward or “
” reverse direction until aerial
platform begins to move, and then return
handle to center position.
Result: Aerial platform should move in
forward or reverse direction, and then
come to a stop.
Test Brakes•
WARNING
Brakes will engage instantly when you
release the controller handle, causing
aerial platform to stop immediately.
1. Ensure path of intended motion is clear.
2. Activate and hold “
” enable trigger
switch.
3. Drive aerial platform “
” forward. Test
brake by releasing controller handle.
Result: Aerial platform should come to
a stop. If aerial platform pulls to one side
while stopping, do not operate aerial
platform until brake adjustments have
been checked.
4. Drive aerial platform “
” forward. Test
brake again by releasing “
” enable
trigger switch only.
Result: Aerial platform should come to an
instant and abrupt stop. If aerial platform
does not stop immediately, or if aerial
platform pulls to one side while stopping,
do not operate aerial platform until brake
adjustments have been checked.
Horn
Lift/Drive/Steer
Enable Trigger Switch
Rocker Switch
Lift/Drive/Steer Controller
Operation Light
Lift/Off/Drive Switch
Base/Off/Platform
Key Switch
Emergency Stop
Button

Skyjack Rough Terrain 800E Series Specifications

General

Brand	Skyjack
Model	Rough Terrain 800E Series
Category	Scissor Lifts
Language	English