EasyManuals Logo

Skyjack SJ16 Operation Manual

Skyjack SJ16
84 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #43 background imageLoading...
Page #43 background image
43
SJ12, SJ16 213721AAA
Function tests Section 4 – Inspections Before Operation
4.3-16 Do a test of the elevated travel
speed
WARNING
Look for overhead obstructions or other possible
hazards around the MEWP when you raise the
platform. Do not lower the platform unless the area
below is clear of personnel and obstructions. If
you do not obey, there is a risk of death or serious
injury.
1. Pull the emergency stop button
4
.
2. Make sure the path of intended motion is clear.
3. Raise the platform until it is at a height of
approximately 60 cm (2 ft).
4. Drive the MEWP forward and then rearward.
Result: The MEWP drives slower than when it
was in the lowered travel position.
5
4
3
1
6
2

Table of Contents

Other manuals for Skyjack SJ16

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Skyjack SJ16 and is the answer not in the manual?

Skyjack SJ16 Specifications

General IconGeneral
Gradeability25%
Drive Motor24V DC
Max Gradeability25%
Platform Height16 ft
Lift Capacity500 lbs
Machine Width0.76 m
Overall Width0.76 m
Drive Speed (Stowed)4.8 km/h
Drive Speed (Raised)0.8 km/h
Turning Radius (Inside)0 in
Power Source24V DC Electric

Related product manuals