45
Operator’s Checklist Section 4 – Inspections Before Operation
P N/A Comment (if item does not pass inspection)
Visual and Daily Maintenance Inspections
Labels - Do an inspection for damaged, or missing labels
Electrical - Do an inspection for loose, damaged, or missing components
Limit switches - Do an inspection for damaged, or missing labels
Hydraulic - Do an inspection for loose, damaged, or missing components
Base - Do an inspection for loose, damaged, or missing components
Base weldment
Steer cylinder assembly
Battery charger
Pothole protection device
Wheel/tire assembly - Do an inspection for loose, damaged, or missing
components
Wheel/tire assembly
Platform assembly - Do an inspection for loose, damaged, or missing
components
Platform
Fall protection anchorages
AC power socket
Platform control console
Manual storage box
Hydraulic/electrical compartment - Do an inspection for leaks and loose,
damaged, or missing components
Batteries
Manifold
Hydraulic tank
Hydraulic oil level
Hydraulic pump and motor
Steer cylinder assembly
Steer linkages
Wheel/motor assembly
Motor contoller
Tilt sensor
Pothole protection limit switches
Lift mechanism- Do an inspection for loose, damaged, or missing compo-
nents
Mast assembly
Wear pads
Chains
Serial Number:
Model:
Hourmeter Reading:
Date:
Time:
N/A NOT APPLICABLE
Operator’s Name
(Printed):
Operator’s Signature:
Each item shall be inspected using the appropriate section
of the Skyjack operating manual. As each item is inspected,
check or complete the appropriate box.
Daily Operator’s Checklist
P PASS
Add a comment if the item does not pass inspection.
NOTE: Make a copy of this page or go to www.skyjack.com for a copy that you can print.
4.4 Operator’s Checklist
(page 1 of 2)
To Next Page
Loading...
Need help?
General
