Skytron AURORA LED Series User Manual

Page 5
NOTE
•Roomplacementofthewallcontrol
will vary by application. Always follow
current standards from the NFPA and
NEC (National Electrical Code) for
proper compliance.
•Theselectionofanchoragefasteners
shall be determined by the engineer on
record and will vary by application. The
selected fasteners must not interfere
with wall control components.
NOTE
Seismic applications require the use of
approved fasteners. Calculations are
available upon request.
CAUTION
Avoid "hanging" the front face plate
assembly.
NOTE
Connection leads shall be constructed
in such a manner that moveable leads
in normal use are not bent around a
radius of less than five times the outer
diameter of the lead concerned. Avoid
conditions employing severe bends to
ensure the integrity of conductors.
NOTE
Determine correct placement for each
Balance Mechanism (BOM)/Vertical
Support Tube (VST) on the radial arm
assembly. The longest VST goes into
the top radial arm.
WARNING
Apply Blue Loc-Tite to all of the 6mm
mounting screws and use a 4mm allen
wrench to tighten the screws.
CAUTION
The 6mm mounting screws for attaching
the VST to the radial arm may be dif-
ferent lengths. Observe any color code
markings and make sure the proper
screws are installed in the proper holes
to avoid any damage to the electrical
components.
WARNING
DO NOT remove lighthead when
support arm is in down position; The
balance mechanism will be severely
damaged and may result in bodily
injury.
NOTE
•3/4" metal conduit and minimum
12AWG wire (3 wires per lighthead)
is required between Wall Control and
Fixture.
•Separatededicatedconduitrequiredfor
120VAC supply lines to wall control.
•Allwiringtobeinaccordancewithlocal,
state and national electrical codes.
SPECIAL USER ATTENTION

Skytron AURORA LED Series Specifications

General

Brand	Skytron
Model	AURORA LED Series
Category	Medical Equipment
Language	English