SMA SUNNY BOY 2000HF - Changes Via Rotary Switches after Installation of the Quick Module

SMA Solar Technology AG The communication module (Quick Module)
Installation Guide SB20_25_30HF-IEN102911 33
5.4.1 Changes via rotary switches after installation of the
Quick Module
If you have already connected the Quick Module to the inverter and would like for example to
configure the installation country or the display language via the rotary switches, then proceed as
follows:
1. Disconnect the inverter on the AC and DC sides as described in section 8”Disconnect the
Inverter from Voltage Sources” (page60).
2. Pull the Quick Module out to the first stopper.
3. Flip the flap up and pen the lid until it locks in place.
4. See section 5.3.4”Setting the Country Standard and Language using Rotary Switches”
(page29) for setting the installation country and the display language.
5. See section 5.3.5”Communication via Bluetooth” (page30) for assigning the NetID via
Bluetooth.
6. Close the lid of the Quick Module and flip the flap
down again until it locks into place.