SMA SUNNY BOY 2000HF - Replacing the Enclosure Lid

SMA Solar Technology AG Decommissioning
Installation Guide SB20_25_30HF-IEN102911 81
12.2 Replacing the Enclosure Lid
In the event of a fault it can be that your inverter must be replaced. In this case you receive a
replacement device with a transport lid.
Prior to returning your inverter to SMA Solar Technology AG, you must swap over the enclosure lid
of your inverter with the corresponding transport lid.
1. Dismantle the inverter as described in section 12.1”Dismantling the Inverter” (page80).
2. Loosen the screws of the enclosure lid.
3. Remove the enclosure lid.
4. Remove the transport lid from the replacement
device in the same manner.
Now mount the transport cover of the replacement device onto your inverter:
1. Put on the transport cover.
2. Tighten the screws.
☑ You can now send your inverter with transport cover to SMA Solar Technology AG.
3. Fix the enclosure lid of your inverter onto the replacement device.
4. Mount (see section 4”Mounting the Device” (page16)) and connect the replacement device
as described in section 6”Electrical Connection” (page38).