The communication module (Quick Module) SMA Solar Technology AG
28 SB20_25_30HF-IEN102911 Installation Guide
5.3.3 Opening the Quick Module
1. If the Quick Module is already connected to the inverter, proceed as follows:
– Disconnect the inverter on the AC and DC sides as described in section 8”Disconnect the
Inverter from Voltage Sources” (page60).
– Pull the Quick Module out to the first stopper.
2. Flip the lower flap of the Quick Module up.
3. Open the lid of the Quick Module, until it locks in
place.
☑ The Quick Module is opened. You can now set the installation country and the language via
the rotary switches as described in the following section.
To Next Page
Loading...
