SMA America, LLC Troubleshooting
Technical Description SI5048U-TUS121440 205
20.8.7 Category SYS
Display no. Level Description
F702 5 DSP reset
F703 2 Timeout during a task
F704 4 Invalid DSP calibration
W705 1 DSP watchdog has been triggered
F706 4 Watchdog meter has expired
(watchdog triggered several times in succession)
W707 1 Watchdog meter on slave 1 has expired
(watchdog triggered several times in succession)
W708 1 Watchdog meter on slave 2 has expired
(watchdog triggered several times in succession)
W709 1 Watchdog meter on slave 3 has expired
(watchdog triggered several times in succession)
F710 4 Autostart meter has expired (several autostarts in succession)
W713 1 Watchdog has been triggered
F716 2 Measuring range of battery voltage exceeded
W717 1 Measuring range of battery voltage exceeded on slave 1
W718 1 Measuring range of battery voltage exceeded on slave 2
W719 1 Measuring range of battery voltage exceeded on slave 3
F720 4 Short-circuit or cable break on transformer temperature sensor
F721 4 Short-circuit or cable break on heat sink temperature sensor
W722 1 Short-circuit battery temperature sensor
W723 1 Cable break on battery temperature sensor
W724 1 Autostart counter has expired slave 1
W725 1 Autostart counter has expired slave 2
W726 1 Autostart counter has expired slave 3
F731 4 Error in the cluster configuration
F732 4 Error in the address assignation of the cluster devices
F733 4 No message from cluster master (only slave)
W734 1 No message from cluster on slave 1
W735 1 No message from cluster on slave 2
W736 1 No message from cluster on slave 3
W738 1 Synchronization not successful
F739 3 Internal communication of the master is interrupted
W740 1 Internal communication of the slave 1 is interrupted
W741 1 Internal communication of the slave 2 is interrupted
W742 1 Internal communication of the slave 3 is interrupted
To Next Page
Loading...
