SMA SUNNY TRIPOWER 5.0 SMART ENERGY - Page 21

4 Product Overview
SMA Solar Technology AG
Operating Manual STPx0-3SE-40-BE-en-10 21
SMASpeedwire
The product is equipped with SMASpeedwire as standard. SMASpeedwire is a type of
communication based on the Ethernet standard. SMASpeedwire is designed for a data transfer
rate of 100Mbps and enables optimum communication between Speedwire devices within
systems.
The products supports the encrypted system communication with SMA Speedwire Encrypted
Communication. In order to be able to use the Speedwire encryption in the system, all Speedwire
devices, except for the SMAEnergyMeter, must support the function SMA Speedwire Encrypted
Communication.
SMA Webconnect
The product is equipped with a Webconnect function as standard. The Webconnect function
enables direct data transmission between the product and Internet portals SunnyPortal and
SunnyPlaces without any additional communication device and for a maximum of 4 products per
visualized system. In PV systems with more than 4 products, there is the option of establishing data
transmission between the products and SunnyPortal via the data logger (e.g.
SunnyHomeManager) or distributing the inverters over several systems. If there is an existing Wi-Fi
or Ethernet connection, you can directly access your visualized system via the web browser on your
smart device (e.g. smartphone, tablet or laptop).
Wi-Fi connection to SMA 360° app and SMA Energy app
There is a QR code on the product by default. By scanning the QR Code attached to the product
via the SMA 360° app or SMA Energy app, access to the product is established via Wi-Fi and the
connection to the user interface is made automatically.
Wi-Fi
The product is equipped with a Wi-Fi interface as standard. The inverter is delivered with the WLAN
interface activated as standard. If you do not want to use WLAN, you can deactivate the WLAN
interface.
Modbus
The product is equipped with a Modbus interface. The Modbus interface is deactivated by default
and must be configured as needed.
The Modbus interface of the supported SMA products is designed for industrial use – via SCADA
systems, for example – and has the following tasks:
• Remote query of measured values
• Remote setting of operating parameters
• Setpoint specifications for system control
• Controlling the battery
Grid management services
The product is equipped with service functions for grid management.
Depending on the requirements of the grid operator, you can activate and configure the functions
(e.g. active power limitation) via operating parameters.