SMA SUNNY TRIPOWER 5.0 SMART ENERGY - Procedure when Replacing a Battery; Procedure

14 Procedure when Replacing a Battery
SMA Solar Technology AG
Operating ManualSTPx0-3SE-40-BE-en-10120
14 Procedure when Replacing a Battery
When a connected battery is replaced by a new battery, the battery configuration must be
performed.
Procedure:
1. Disconnect the inverter from all voltage sources (see Section10, page86).
2. Connect new battery (see (see Section7.7, page61) and (see Section7.5.3, page50)).
3. Recommission the inverter (see Section8.2, page63).
4. Open the user interface (see Section9.1, page66).
5. Log in as Installer.
6. Start the installation assistant (see Section9.6, page74).
7. Click on [Save and next] for each step up to the step Battery configuration.
☑ The new battery has been automatically detected and is already configured.
8. Select Save and next until the Summary is displayed.
9. Check the configuration in the summary.
10. Select Next.
☑ The battery configuration is being updated. The new battery is captured.