SMA SUNNY TRIPOWER 5.0 SMART ENERGY - Establishing a Connection via Ethernet in the local network

9 Operation
SMA Solar Technology AG
Operating Manual STPx0-3SE-40-BE-en-10 67
SSID, IP address and WLAN password
• SSID in WLAN: SMA[serial number] (e.g. SMA0123456789)
• Device-specific WLAN password: see WPA2-PSK on the type label of the product or the
rear side of the manual included in delivery
• Standard access address for a direct connection via WLAN outside of a local network:
https://smalogin.net or 192.168.12.3
Connection to SMA 360° App
Requirements:
☐ A smart device with camera (e.g. smartphone or tablet) must be available.
☐ The SMA 360° App must be installed on the smart device.
☐ An user account for SunnyPortal must already exist.
Procedure:
1. Open the SMA 360° App and login with the SunnyPortal account details.
2. Select QR-Code Scan in the menu.
3. Scan the QR Code on you product via the SMA 360° App.
☑ The smart device automatically connects to the product. The web browser of your smart
device opens and the login page of the user interface is displayed.
4. If the web browser of the smart end device does not open automatically and the login page of
the user interface is not displayed, open the web browser and enter https://smalogin.net in
the address bar.
9.1.3 Establishing a Connection via Ethernet in the local
network
New IP address for connecting with a local network
If the product is connected to a local network (e.g. via a router), the product will receive a new
IP address. Depending on the type of configuration, the new IP address will be assigned
automatically by the DHCP server (router) or manually by you. Upon completion of the
configuration, the product can only be reached via the following access addresses:
• Generally applicable access address: IP address manually assigned or assigned by the
DHCP server (router) (identification via network scanner software or network
configuration of the router).
• Access address for Apple and Linux systems: SMA[serial number].local (e.g.
SMA0123456789.local)
• Access address for Windows and Android systems: https://SMA[serial number] (e.g.
https://SMA0123456789)
Requirements:
☐ The product must be connected to the local network via a network cable (e.g. via a router).
☐ The product must be integrated into the local network. Tip: There are various methods of
integrating the product into the local network with the aid of the installation assistant.