6 Mounting
SMA Solar Technology AG
Operating ManualSTPx0-3SE-40-BE-en-1036
3. Insert screw anchors into the drill holes if the support surface requires them.
4. Secure the wall mounting bracket horizontally using
screws and washers.
5. Hook the inverter into the wall mounting bracket. To
do this, the 2 bolts on the right and left between the
ribs on the back of the inverter must be hooked into
the keyways of the wall mounting bracket.
6. Ensure that the inverter is securely in place.
7. Secure the inverter to the wall mounting bracket on
both sides with a pan head screw (M4x14)
provided. Use a magnetized screwdriver to insert a
screw into the lower screw hole of the inverter's
anchorage bracket and tighten it (PH2, torque:
1.5Nm).
8. Remove the protective cover from the connection
area.
To Next Page
Loading...
