9 Operation
SMA Solar Technology AG
Operating Manual STPx0-3SE-40-BE-en-10 85
Procedure:
1. Open the user interface (see Section9.1, page66).
2. Log into the user interface as an Installer (see Section9.2, page69).
3. Select the menu Device Configuration.
4. In the product row, click on the gear icon and select Update firmware.
5. Select [Browse] and select the update file for the product.
6. Select Update firmware.
7. Follow the instructions in the dialog.
☑ The firmware update is installed. The installation takes about 15 minutes.
8. Open the user interface and check the events to see whether the firmware update has been
completed successfully.
Searching and updating firmware via the user interface
Requirement:
☐ The inverter must be connected to the Internet.
Procedure:
1. Open the user interface (see Section9.1, page66).
2. Log into the user interface as an Installer (see Section9.2, page69).
3. Select the menu Device Parameters.
4. Click on [Edit parameters].
5. Go to Device > Update.
6. Select the parameter Check for update and install it and set it to Execute.
7. Click on [Save all].
☑ The firmware is updated in the background.
To Next Page
Loading...
