SMAR TP303 - Page 7

Table of Contents
VII
I
nsta
ll
at
i
on
Fl
owc
h
art
Quick Installation Guide
Has the transmitter
been configured
in bench for the
application ?
Configure the transmitter
( section 1 and section 3).
Start
Field Installation.
Install the transmitter in
protected areas.
Install the transmitter (mechanically
and electrically) according to the
application, verifying the most
appropriate position of the LCD.
Verify area classification and
its respective practices.
NO
YES
Configure Fail Safe value
(Section 3).
Configure Damping (Section 3).
Configure the indication in LCD
(Section 3).
Configure the user unit in case
of specific measurements.
Is the measurement
OK ?
NO
YES
Is
?
the
measuring ok
OK
NO
Using the GSD file, configure
the cyclic data in the system
configuration tool (Section 3)
YES
Consult the manual
Section 4 - Maintenance.
Consult the manual
Section 4 - Maintenance.
Dislocate the system to
upper position, execute the
upper position trim for 100%.
Dislocate the system to
lower position, execute the
lower position trim for 0%.
Power the transmitter appropriately.
Fix the transmitter magnet
in a position that allows to the
sensor to travel all magnet range.