SMART Board GX V2 Series - Chapter 4 Maintaining the Display; Default Chapter; Turning the Display on or off

smarttech.com/kb/171861 53
Chapter 4 Maintaining the display
Turning the display on or off 53
Cleaning and maintaining the display 54
Checking the display installation 54
Cleaning the screen 55
Cleaning the touch sensors 55
Maintaining ventilation 56
Preventing condensation 56
Replacing the pens 56
Removing and transporting the display 57
Updating system firmware 58
Applying a firmware update 58
With proper maintenance, the display will provide years of use.
Turning the display on or off
In most situations, you can put the display in Standby mode when not using it by following the
instructions in SMART Board GX (V2) series interactive displays user guide (smarttech.com/kb/171862).
In some situations, such as when you move the display or clean its screen, you need to turn the display
off. You can turn it back on after.
To turn the display off
1.
Press and hold the Power button on the front control panel for three seconds to begin a 10
second countdown before the display enters Standby mode and the status light stops blinking.
OR
Press the Power button on the remote control to begin a 10 second countdown before the
display enters Standby mode and the status light stops blinking.