SMART Board GX V2 Series - Input Commands; Brightness Commands

Appendix C Managing the display using RS-232
smarttech.com/kb/171861 97
Power state Description
POWERSAVE The screen is off, and the display is in a very low power state. The display enters
READY or ON state when one of the following occurs:
l
A user presses the Power button on the front control panel or the remote
control.
l
You send the setpowerstate=ready or setpowerstate=on command.
This power state is the default energy saving mode for displays set to an EU
location.
Note
The EU uses “Standby” to describe this power state.
Input commands
Get command Set command Response
get input set input[Value]
Where [Value] is one of the following:
l
=hdmi1
l
=hdmi2
l
=hdmi3
l
=vga
l
=ops
l
=type-c1 [or usbc1]
=type-c1 [or usbc1]
l
=dp
l
=android
input=[Value]
Where [Value] is one of the following:
l
hdmi1
l
hdmi2
l
hdmi3
l
=vga
l
=ops
l
=type-c1 [or usbc1]
=type-c1 [or usbc1]
l
=dp
l
=android
Brightness commands
Get command Set command Response
get brightness set brightness[Value]
Where [Value] is one of the following:
l
+[Value]
l
-[Value]
l
=[0–100]
brightness=[Value]
Where [Value] is a number between 0
and 100