SMART LightRaise - Page 28

20 SMART LightRaise Installation and User's Guide
4
Use the pencil to mark the hole locations for the toggle bolt anchors.
Console Bracket
Keyholes
Toggle Bolt Anchor Locations
5
Use the stud finder to locate the studs. Mark the intersection of the top and bottom set of
slots with the center of the studs. You'll have marked two locations for each stud.
Console Bracket
Metal Studs
Mark toggle bolt anchor
locations where studs
intersect the slots
Outer Toggle Bolt Anchor Locations
Bottom Set of Slots
Top Set of Slots
6
Remove the console bracket.
7
For each marked location, drill a ¼"
(6 mm)
pilot hole and then the final ½"
(13 mm)
hole
through the drywall at each toggle bolt anchor location.
8
For each toggle bolt anchor location, insert the metal end of a toggle bolt anchor through
the hole by bending the end so that it lies against the plastic as the toggle bolt anchor
moves into the hole. The metal end straightens against the inside of the drywall to create
an anchor.
Plastic Handle
Metal End