32 SMART LightRaise Installation and User's Guide
To lay the cables and snap on the top covers:
1
Locate the cable bundle for the projector.
2
Start at the projector end of the boom. Leaving enough cable length to connect the
projector (approximately 24"
[61.0 cm]
), lay the cables along the boom, inside the cable
management trough.
The cables will extend the entire length of the trough, from the projector mount, between
the gap in the strut slide to the boom hinge end. Make sure the excess cable length hangs
past the end of the boom shaft.
Projector Mount
Strut Slide
Boom Hinge End
Cables Inside Cable
Management Trough
Cable Tie
Wrap
3
Insert a tie wrap into the tie wrap mount, which was attached to the projector mount at the
end of the boom. Secure the cables with this wrap.
4
Snap the two plastic top covers into the cable management trough.
Telescoping Beam
Top Cover
Main Beam
Top Cover
NOTE:
You may have to cut the end of the telescoping beam cover. Measure the cable
trough and use the plastic cutting tool. Be careful to cut the cover at the correct length.
To Next Page
Loading...
