36 SMART LightRaise Installation and User's Guide
4
Slide the upper boom cover's flange into the lower cover's groove and then slide the upper
boom cover around the pivot base and over the upper boom bracket. Ensure the cables
are inside the cover and aren't pinched or bent.
Pivot Base
Pivot Cover
5 To install the upper boom cover on a concrete or cinder block wall,
use the supplied
masonry drill bit to drill holes at the two hole locations in the cover. Insert a concrete
screw into each hole and use the Phillips hand screwdriver to tighten each screw.
To install the upper boom cover on a wall with studs,
mark the two hole locations in
the cover and then remove the cover. Use the Phillips screwdriver to insert a drywall
anchor into each marked location. Follow steps 3 and 4 to return the upper cover to its
place. Insert a #8 x 1¼" truss head screw into each drywall anchor and use the Phillips
hand screwdriver to tighten each screw.
Truss Head
Screws
To Next Page
Loading...
